|
Several processes, in both hardware and software, are hard
at work to allow you to have a complete and safe recovery
from power fails. First, a Maccor data file contains information
that allow tests to resume from the most recent record stored
in the file. Second, all systems presently supplied by Maccor
have power fail detection hardware. Thus, by correctly installing
a UPS, the software shuts down the system in an orderly fashion
to allow the system to recover with no loss in data. The power
fail detection hardware does more than just monitor the incoming
AC. The power fail detection hardware also monitors the voltage
of the logic power supplies preventing systems from damaging
the devices under test.
Shelves for the
cabinet's interface are available. Shelves reduce the cabling
needed by allowing you to test the devices at the tester interface.
 The adjustable cylindrical cell holder may be mounted
on the cabinet's interface or remotely. The cell holder is
available in blocks of eight and adjustable from button to
18650 cell sizes.
The coin/button
cell holder is adjustable for a variety of cell diameters.
With a thumb screw terminal on one end and a spring loaded
terminal on the other it makes perfect contact every time.
These cell holders are mounted on a circuit board and plug-in
directly to the cabinet's interface.
The first and only
true four-wire cell holders are available in a variety of
sizes including: AAA, AA, C, D, and 9 Volt. These cell holders
provide the most accurate measurements at the cell. Cell holders
are mounted on a circuit board with either power pole or phoenix
connectors.
Cables are Four-wire
terminated with power-pole for tester interface, and your
choice of alligator clips, spade or ring lugs, banana plugs,
or kelvin clips for user interface.
If you require further
information about this product or service please contact us
here
|
